E-speed flyer fomr x-flight.hk

The main wing anchoring is not pre-drill but it should be easy.



Some bit on the side needs to be dremel away to avoid binding witht the aileron linkage.

Very streamline and smart look. I get bored with the look of a typical pylon. This one looks great. The rudder fin is not added yet.

All pieces out of box. All hinge, linkage wires, horns, and spinner .... are included.

• MaterialFibre glass fuselage, balsa sheet foam core main wing.

• Wing Span916mm• Length800mm

Flying weight: with 3s 2200mAH, 680g

My first pylon. Fiberglass fuselage. Very superb painting. Installation needs some tools like drill , as you need to drill holes for the link rods, ,main wing anchoring etc.

Very fast pylon, with very light setup of 3s 3000kv @30A , 4.5x 4.1 APC, the speed reach 160km/hr. I used my old trex450 450TH motor. The motor is over 200 flight before and the front bearing is worn off. Cause vibration at 2/3 throttle.

Now upgraded to 4s 3600kv motor, rated 52A with 4.1x 4.1 APC. Plan to break my 200 kph speed limit.