Repair Spektrum BR6000

Found my BR6000 cannot bind , but function normally with the previous model name. So must be the binding chanel have problem. Number one suspicious is the binding circuit broken. Using an ohmeter confirm the an open circuit between the signal pin for binding channel and the resistor R1.

Test if binding works again with a jumper wire. Bingo !!Solder the jumper pin back to the R1 resistor. This is not too difficult if you have a special soldering head with a fine tip. Also use a small 30W and limit you soldering time <3 seconds. Otherwise, the R1 will fall off and you need a magnifying glass to look for it again.